Davolink DV-332 - Individual SIP Port Configuration

DV-332 Analog/Digital User Guide
28
6. Send a no-sdp(18x) - NO
7. With a NTE(INV/18x/200) - YES
===========================================================================
GW/CONFIG/VOIP>
GW/CONFIG/VOIP>
But engagement with KT, it is necessary to setup additional P-Asserted articles as below. The below
setting shall setup the Number which is set p-asserted No table related to VoIP.
GW/CONFIG/VOIP> pafield ©
usage : pafield addr|voip|user|null
addr : /config/address table
voip : /config/voip p-asserted number table
user : user's calling number. Ex)fxo's cid | trunk intf's calling number
current pafield(p-asserted) value is NULL
GW/CONFIG/VOIP>
GW/CONFIG/VOIP> pafield voip ©
GW/CONFIG/VOIP>
GW/CONFIG/VOIP> pafield ©
usage : pafield addr|voip|user|null
addr : /config/address table
voip : /config/voip p-asserted number table
user : user's calling number. ex)fxo's cid | trunk intf's calling number
current pafield(p-asserted) value is voip
GW/CONFIG/VOIP>
5.1.2 Setting each SIP port
After setting totally, it can change each port. Used order command is “port easyconfig”
GW/CONFIG/VOIP> port©
usage : port_easyConf sipIndex#
GW/CONFIG/VOIP> port 1©
=======================================================
*. If you don't need to change the value,
you have to type the [ENTER] key.
=======================================================
Server Mode [current : OUTBOUND ]
[0:OUTBOUND/1:PROXY] : ©
Proxy Address [current : 59.18.4.17 ]
[domain | ip_addr | none] : ©
Proxy Port [current : 5060 ]
[1025 ~ 65535] : ©
Registrar Address [current : 59.18.4.17 ]
[domain | ip_addr | none] : ©