EasyManua.ls Logo

Davolink DV-332 - Isdn Pri

Davolink DV-332
105 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DV-332 Analog/Digital User Guide
56
GW/CONFIG/AR2> change dmode enbloc ©
GW/CONFIG/AR2> change rsend off ©
6.3.2 ISDN PRI
ISDN PRI is the most commonly used signaling type. Because connecting time of ISDN PRI when
sending a call is relatively faster than that of R2 MFC. Unlike R2 MFC, ISDN PRI sends Q.931
messages.
GW/CONFIG/ISDN> show 0 ©
==========================================================================
ISDN Configurations(0)
==========================================================================
Protocol Mode (prmode) : (ISDN_ETSI_MODE)
Operation Mode (opmode) : (ISDN_NET_MODE)
Dialing Mode in O/G Call SETUP (dmode) : (ENBLOC_DIAL)
Dial tone send in seizure (dsend) : ON
Ringback tone send in alert (rsend) : ON
Send ALERT on receiving PROGRESS (alprog) : OFF
off tone on opening of voice channel(ftvc) : after 0 sec
Pseudo ringback tone send in alert (prsend) : OFF
Dial Tone Type (dtype) : TONE_DIAL_CONT
wait first INFO timer (fit) : 15 sec
wait second INFO timer (sit) : 3 sec
wait post INFO timer-Enbloc Peer (pit) : 3 sec
wait last INFO timer (lit) : 4 sec
Speed dial timeout (sdt) : 4 sec
Q931 Timer - Call Delivered (t301) : 180 sec
Q931 Timer - Call Initiated (t303) : 4 sec
Q931 Timer - Overlap Sending (t304) : 30 sec
Q931 Timer - Disconnect Request (t305) : 30 sec
Q931 Timer - Release Request (t308) : 4 sec
Q931 Timer - Connect Request (t313) : 10 sec
Q931 Timer - Resume Request (t318) : 4 sec
Q931 Timer - Suspend Request (t319) : 4 sec
One digit per one info in overlap dial(oned) : (ON)
ISDN Calling Party Numbering Plan (cnpn) : (NI2_NPLN_NATIONAL_ISDN)
Include ISDN Calling Party Number (icpn) : ON
ISDN Called Party Numbering Plan (cdpn) : (NI2_NPLN_NATIONAL_ISDN)
Information Transfer Capability (itcap) : (IITC_SPEECH)
Incoming Call DIL mode (icdil) : OFF
send RESTART msg. on startup (rstart) : OFF
Ignore unexpected element on SETUP (iue) : OFF
Ignoring CG/Busy Tone (icbt) : OFF
Progress Indicator value (piv) : 1

Table of Contents