Davolink DV-332 - Page 55

DV-332 Analog/Digital User Guide
55
If you type “change” command as follows, you can see the usage.
GW/CONFIG/AR2> change ©
==========================================================================
Configuration Change Command Usage
==========================================================================
change <parameter> <value>
==========================================================================
parameter ; dmode - dialing(address sending) mode [O/G]
; stype - R2 line signaling type
; rsend - ringback tone send in seizure [I/C]
; ftvc - off tone on opening of voice channel [I/C]
; prsend - pseudo ringback tone send [I/C]
; asend - alert message send to network [O/G]
; sdt - speed dial timeout
; t1 - Seizure Guard Time [I/C]
; t2 - Clear Foward Guard Time [I/C]
; t3 - Clear Foward Wait Guard Time [I/C]
; t4 - Seizure Ack Guard Time [O/G]
; t5 - Seizure Ack Duration [O/G]
; t6 - Answer Guard Time [O/G]
; t7 - Clear Backward Guard Time [O/G]
; t8 - Release Guard Time [O/G]
; t9 - Reanswer Guard Time [O/G]
; t10 - Release Wait Guard Time [O/G]
; t11 - Block Detect Guard Time [O/G]
; t12 - Glare Detect Guard Time [O/G]
; t13 - If glare is detected, stay seizure [O/G]
; icbt - Ignoring CG/Busy Tone
; prel - Playing REL-tone to the R2
; ia6 - Ignoring ACOMP(A6|A3) sig
value ; dmode - overlap|enbloc
; stype - wink(wink-start) [E1]
; dsend,rsend - on|off
; ftvc - after 0 ~ 59 sec, 60 = off
; prsend - off|setup|callproc
; sdt - 1 ~ 10 sec
; t1~11 - 0 ~ 1000 (ms)
; t3 - 1000 ~ 60000 (ms)
; t4,12,13 - 100 ~ 10000 (ms)
; t8,10 - 0 ~ 10000 (ms)
; icbt - on | off
; prel|ia6 - on | off
==========================================================================
GW/CONFIG/AR2>