DV-332 Analog/Digital User Guide
54
Dial interval (intv) : 100 ms
Dial Tone Type (dtype) : TONE_DIAL_CONT
------------------------------------------------------
Seizure Guard Time (t1) : 60 ms
Clear Foward Guard Time (t2) : 200 ms
Clear Foward Wait Guard Time (t3) : 30000 ms
Seizure Ack Guard Time (t4) : 1000 ms
Seizure Ack Duration (t5) : 360 ms
Answer Guard Time (t6) : 200 ms
Clear Backward Guard Time (t7) : 200 ms
Release Guard Time (t8) : 200 ms
Reanswer Guard Time (t9) : 200 ms
Release Wait Guard Time (t10) : 1000 ms
Block Detect Guard Time (t11) : 640 ms
Glare Detect Guard Time (t12) : 200 ms
If glare is detected, stay seizure(t13) : 500 ms
Ignoring CG/Busy Tone(icbt) : OFF
==========================================================================
GW/CONFIG/AR2>
Most of default values above are widely used ones. Therefore, you do not have to change them
when installing and configuring. Sometimes you can change following options.
dialing Mode (dmode) : This field defines the method to send dialed digits via lines using R2 MFC.
Overlap mode sends each digit right after pressing it. And enbloc mode stores whole digits and send
them later.
ringback tone send in alert (rsend) : After receiving alerting message, this field defines whether GW
plays ringback tone or not.
alert msg send to network (asend) : This field defines whether GW sends alerting message to
network.
I/C Calling Party Addr Request (sareq) : When receiving a call, this field defines whether GW
requests the calling number to sender. If it is off, calling numbers will not be shown.
wait second digit timer (sdwt) : This field defines the a waiting time between two digits. If you set
up this time too short, a call can be made during the dialing process.
wait post digit timer-Enbloc Peer (pdwt) : This field defines a waiting time after dialing.
To Next Page