Davolink DV-332 - 10 Saving

DV-332 Analog/Digital User Guide
100
After finishing firmware upgrade as you can see above, Please reboot the GW. Then, it will be run
based on a newly upgraded firmware.
GW:/SYSTEM> reset©
Are you sure(y/n)?y©
Saving configuration value(y/n)?y© /*it will save changes*/
Saving.....TConfig Writing Done
Done
You can verify whether firmware was successfully upgraded or not by following command.
GW/SYSTEM> version©
┃
┃ [S/W APP]
┃ VERSION : 02.03.04
┃ LINKTIME : 2007/10/12
┃ PROTOCOL : SIP/2.0
┃ LANGUAGE : KOR
┃ SNMP : DAVOLINK
┃ SUPPORTED B/D : FCU FSU FTU EMU
┃ [B O O T]
┃ VERSION : 0.00
┃ [H / W]
┃ VERSION : 1.0
┃ MPU_ID : MPU332D
┃ SLOT INFO : FCU(FXS4+FXO4) + UNKNOWN + UNKNOWN + UNKNOWN
┃
GW/SYSTEM>
As you can see above, you can verify the firmware by checking the version and linktime.
If you connect GW via RS232C console cable, this information will be automatically seen right after
rebooting.
Note: You can also apply DV-332 firmware into DV-232 products. But the message is slightly
different from the previous one.
┃
┃ [S/W APP]
┃ VERSION : 02.03.04