Davolink DV-332 - Signaling Type Configuration

DV-332 Analog/Digital User Guide
53
6.3 Configuring signaling types
6.3.1 R2 MFC
R2 MFC is the commonly used signaling type in old central office switches. Although the number of
users is decreasing, it’s still widely used. Note that signals are transmitted by analog tones. The
disadvantage of R2 MFC type is that it takes longer time to be connected when making a call
comparing to ISDN PRI.
GW/CONFIG/AR2> show ©
==========================================================================
R2 Configurations
==========================================================================
dialing Mode (dmode) : OVERLAP_DIAL
R2 Line signaling type (stype) : R2_LSIG_WINK_START
ringback tone send in alert (rsend) : ON
off tone on opening of voice channel(ftvc) : after 1 sec
pseudo ringback tone send(prsend) : OFF
alert msg send to network (asend) : ON
Speed dial timeout(sdt) : 4 sec
------------------ CAS R2 --------------------------
O/G II-Group signal (categ) : 1
O/G request Charge (charge) : ON
I/C A-Group signal (acomp) : 6
I/C Calling Party Addr Request (sareq) : ON
max number of digits to receive(mrxd) : 0
R2-MFC Tone Output Gain (gain) : -20 dbm
wait first DTMF timer[IVR] (fdwt) : 15 sec
wait second digit timer (sdwt) : 3 sec
wait post digit timer-Enbloc Peer (pdwt) : 3 sec
Enable net overlap digit timer(enodt) : OFF
net overlap digit timer(nodt) : 2 sec
convert the reserved digit(red) : *
send complete accepted digit(sadigit) : ALERT
playing release tone to R2(prel) : OFF
ignore ACOMP sig(ia6) : OFF
------------------ CAS DTMF --------------------------
Dial tone send in seizure (dsend) : ON
wait first DTMF timer (fdwt) : 15 sec
wait second DTMF timer (sdwt) : 3 sec
wait post DTMF timer-Enbloc Peer (pdwt) : 3 sec
Enable net overlap digit timer(enodt) : OFF
net overlap digit timer(nodt) : 2 sec
wait last DTMF timer (ldwt) : 10 sec
Dial guard time (guard) : 200 ms
Dial duration (dur) : 100 ms