DV-332 Analog/Digital User Guide
88
Post digit timeout(pdt) : 2 sec
hook flash guard time (guard) : 600 ms
Ring Vrms Value (vrms) :
60 60 60 60
CODEC filter value : KOREA
No answer timer(natimer) : 180
FXS/FXO|LBU One2One Mode(one2one) :
DISABLE DISABLE DISABLE DISABLE
FXO unblock time(ubtime) : 500 ms
DTMF duration (dur) : 120 ms
DTMF interval (intv) : 60 ms
Wait dialtone (wdt) : 2 sec
Ringing timer (ringing) : 200 sec
Early DTMF (edtmf) : DISABLE
Early DTMF Onhook guard (etime) : 1 sec
Force On-Hook (fon) : DISABLE
ForceOn-HookGuardTimer(ontimer) : 10 sec
Ring trip threshold (rtrip) : DOWN
FXS Codec Receive Gain (rg) : OFF
Private ring number(pri) : none
===========================================================================
GW/CONFIG/FXS>
8.7 Setting the function for showing caller ID
Generally, shown caller ID is that a function of detection. Information of number from PSTN line
shall detect when telephone signal arrives to receiver party. Then, this information will provide to
the phone which connected to FXS port. Normally, domestic Ring signal provides 1 second & 2
seconds take off. And then, Ring signal provides 1 second. It’s the type of ring signal in our nation.
Information of caller ID delivers during the interval between the first Ring signal & second Ring
signal. For this interval (2 seconds), it delivers by FSK method.
To Next Page
Loading...