Davolink DV-332 - Setting up Address Table for Calls between Headquarter and Branches

DV-332 Analog/Digital User Guide
67
NET 0 *1??? 0 220.120.246.204 C
NET 0 0~ 0 0.0.0.0 C
NET 0 ~ 0 02 0.0.0.0 C
======================================================================
*INTF : Invalid Interface
======================================================================
GW/CONFIG/ROUTE>
In the case of digital GW, you have to additionally set up a route to receive calls and send them to
E1 interfaces (CCS or CAS).
GW/CONFIG/ROUTE> add0 ccs 0 *2??? 2©
Prefix Table Add success
GW/CONFIG/ROUTE> show 0©
======================================================================
1st Routing Table Show
======================================================================
INTF PORT NUMBERS TRNC PREFIX POSTFIX DEST_ADDR LEVEL
======================================================================
FXS 200 07077003241 11 0.0.0.0
FXS 200 *99* 4 0.0.0.0
FXO 201 **11~ 4 0.0.0.0
NET 0 *1??? 0 220.120.246.204 C
NET 0 0~ 0 0.0.0.0 C
NET 0 ~ 0 02 0.0.0.0 C
CCS 0 *2??? 2 0.0.0.0
======================================================================
*INTF : Invalid Interface
======================================================================
GW/CONFIG/ROUTE>
7.1.3 Setting up address table for calls between headquarter and branches
You need to add following route to make calls between headquarter and branches. Additionally, you
also set up FXO ports to receive calls from PSTN lines and switch VoIP to PSTN backup lines in
emergency.
GW/CONFIG/ADDRESS> gport fxs 200 all© /*setting up FXS ports as a group to receive PSTN calls*/
GW/CONFIG/ADDRESS> gport fxo 201 0-1© /*setting up 2 FXO ports for PSTN backup lines*/
GW/CONFIG/ADDRESS> gport fxo 202 2-3© /*setting up 2 FXO ports to receive headquarter-branch
calls*/