Davolink DV-332 - Adding and Deleteing a Basic Routing Table

To Next Page

To Previous Page

DV-332 Analog/Digital User Guide

7.1.1 Adding and deleteing a basic routing table

To add and delete routes in a routing table, you can use “add” and “del”. If you do not specify the

port number, it is regarded as routing table “0”. When you want to modify routing table “1”, you

must use “add1” and “del1”.

add, add0, del, del0 : these commands add and delete routes in routing table “0”

add1, del1 : these commands add and delete routes in routing table “1”

GW/CONFIG/ROUTE> del0 all© /* This command will delete all the routes in the table. */

This command deletes all prefix table. Are you sure(y/n)?y©

GW/CONFIG/ROUTE>

Following configurations are routes to call landlines and cellular phones after successful registration

to a server. These should be set up even when you do not use calls between headquarter and

branches.

GW/CONFIG/ROUTE> add0 fxs 200 *99* 4©

Prefix Table Add success

GW/CONFIG/ROUTE> add0 fxs 200 07077003241 11©

Prefix Table Add success

======================================================================

1st Routing Table Show