Davolink DV-332 - Headquarter-Branch Call Setup; Routing Table Configuration

DV-332 Analog/Digital User Guide
63
7. Setting up calls between headquarter and branches
7.1 Routing table configuration
With a new firmware release, you can have two routing tables simultaneously. Thus, you can try
calls referring to two separate routing tables in one gateway.
GW/CONFIG/ROUTE> show©
usage : show <idx>
<idx> : (0) first, (1) second
GW/CONFIG/ROUTE> show 0©
======================================================================
1st Routing Table Show
======================================================================
INTF PORT NUMBERS TRNC PREFIX POSTFIX DEST_ADDR LEVEL
======================================================================
FXS 0 200 3 0.0.0.0
FXS 1 201 3 0.0.0.0
FXS 2 202 3 0.0.0.0
FXS 3 203 3 0.0.0.0
FXO 0 100 3 0.0.0.0
FXO 1 101 3 0.0.0.0
FXO 2 102 3 0.0.0.0
FXO 3 103 3 0.0.0.0
NET 0 ***?? 5 0.0.0.0 C
======================================================================
*INTF : Invalid Interface
======================================================================
GW/CONFIG/ROUTE> show 1©
======================================================================
2nd Routing Table Show
======================================================================
INTF PORT NUMBERS TRNC PREFIX POSTFIX DEST_ADDR LEVEL
======================================================================
======================================================================
*INTF : Invalid Interface
======================================================================
GW/CONFIG/ROUTE>
As you can see above, there are two tables simultaneously. It is common to use just routing table
“0” only. From now on, this document will only use routing table “0”. If you just type “show”
command, it will basically show you routing table “0”.