Davolink DV-332 - Setting Default; Setting H.323

DV-332 Analog/Digital User Guide
41
usage : cfield addr|voip|user|mynum|null
addr : /config/address table
voip : /config/voip contact table
user : user's calling number. ex)fxo's cid | trunk intf's calling number
mynum : operator add prefix calling number
current cfield(contact) value is VOIP
current mynum is NULLGW/CONFIG/VOIP>
Command “cfield” is using for changing contact field. Default “ADDR”
5.2 Setting H.323
5.2.1 Setting Default
Basically, setup G/K IP address, H.323 ID, E.164 number for registration.
GW/CONFIG/VOIP> configure ©
1. RAS Config
2. Protocol Config
3. RTP Config
4. Manual RAS Config
0. exit
Select (0 ~ 3) : 1 ©
* RAS Parameters *
---------------------------------------------------------------------------
Gatekeeper not used.
---------------------------------------------------------------------------
* Registration Numbers *
---------------------------------------------------------------------------
---------------------------------------------------------------------------
* My H323ID *
---------------------------------------------------------------------------
VOIP
---------------------------------------------------------------------------
* Timeout *
---------------------------------------------------------------------------
RRQ timer mode : Received from G/K
RAS response timeout : 5 sec
RAS retry number : 2
Q.931 response timeout : 20 sec
---------------------------------------------------------------------------
* RAS TTL *
---------------------------------------------------------------------------
700