Davolink DV-332 - IP Configuration

DV-332 Analog/Digital User Guide
14
4. IP Configuration
When you log into gateway via console cable, you can use user id:davo and password:drc. You can
set up an IP address as follows.
GW/CONFIG/IP> show©
#===========================================================
#================ WAN PARAMETERS =======================
OP mode - STATIC
WAN IP Address - 192.168.2.200
WAN Subnet Mask - 255.255.255.0
WAN Gateway - 0.0.0.0
Ethernet Addr - 00:08:52:02:CA:FE
#================ CONSOLE PARAMETERS =======================
Console BaudRate - 19200 BPS
#================ DNS PARAMETERS =======================
1st Server IP - 168.126.63.1
2nd Server IP - 168.126.63.2
Domain Name -
#===========================================================
GW/CONFIG/IP>
Factory default values are static mode and 192.168.2.200 respectively. You can change them
depending on environment.
GW/CONFIG/IP> change©
#================ WAN PARAMETERS =======================
OP mode - STATIC
WAN IP Address - 192.168.2.200
WAN Subnet Mask - 255.255.255.0
WAN Gateway - 0.0.0.0
Ethernet Addr - 00:08:52:02:CA:FE
#================ CONSOLE PARAMETERS =======================
Console BaudRate - 19200 BPS
#================ DNS PARAMETERS =======================
1st Server IP - 168.126.63.1
2nd Server IP - 168.126.63.2
Domain Name -
#===========================================================
1. Change Operation mode.
2. Change IP Address.
3. Change IP Netmask.