DV-332 Analog/Digital User Guide
84
===========================================================================
* ADDRESS TABLE SHOW *
===========================================================================
INTF PORT VIRTUAL_NUM PEER-ADDR GROUP-PORT MODE L/RT
===========================================================================
FXS 0 200 NONE 200 Round_Robin C/1ST
FXS 1 201 NONE 200 Round_Robin C/1ST
FXS 2 202 NONE 200 Round_Robin C/1ST
FXS 3 203 NONE 200 Round_Robin C/1ST
FXO 0 100 200 None C/1ST
FXO 1 101 201 None C/1ST
FXO 2 102 202 None C/1ST
FXO 3 103 203 None C/1ST
===========================================================================
GW/CONFIG/ADDRESS>
As setting above, for example, if the phone connected to FXS number 0 port rings, hold the phone
connected to number 3 port & press “0”. Then, receiving calls can answer from number 3ports..
8.5.2 Setting up call transfer feature
When PSTN line is receiving a call through IP or FXO, it will establish the connection to another port.
To setup this function, local call feature mode(va) shall establish with “yes”. This helps GW to
perceive hook flash when connecting the call to another port. Otherwise, it takes the call as
disconnection without perceiving hook flash. Therefore, it needs to check the following
establishment related to hook flash.
GW/CONFIG/FXS> show©
===========================================================================
FXS Configurations Show
===========================================================================
Voice Output Gain (vgain) : dB
-2 -2 -2 -2
PCM Input Gain (igain) : dB
0 0 0 0
Caller id Generation mode (cid) :
DISABLE DISABLE DISABLE DISABLE
ring cadence on time (ron) : 1 sec
ring cadence off time (roff) : 2 sec
Polarity reversal (pola) : DISABLE
Dial Tone Type (dtype) : CONTINUOUS
To Next Page
Loading...