DV-332 Analog/Digital User Guide
85
Initial digit timeout(init) : 10 sec
Inter digit timeout(idt) : 5 sec
Post digit timeout(pdt) : 2 sec
hook flash guard time (guard) : 600 ms
Ring Vrms Value (vrms) :
60 60 60 60
CODEC filter value : KOREA
No answer timer(natimer) : 180
FXS/FXO|LBU One2One Mode(one2one) :
DISABLE DISABLE DISABLE DISABLE
FXO unblock time(ubtime) : 500 ms
DTMF duration (dur) : 120 ms
DTMF interval (intv) : 60 ms
Wait dialtone (wdt) : 2 sec
Ringing timer (ringing) : 200 sec
Early DTMF (edtmf) : DISABLE
Early DTMF Onhook guard (etime) : 1 sec
Force On-Hook (fon) : DISABLE
ForceOn-HookGuardTimer(ontimer) : 10 sec
Ring trip threshold (rtrip) : DOWN
FXS Codec Receive Gain (rg) : OFF
Private ring number(pri) : none
===========================================================================
GW/CONFIG/FXS>
Hook flash guard time(guard) shall establish the pressing time when user presses hook switch.
Normally, it measures 150~200ms for pressing hook flash button with standard phone. If user presses
& releases, it will be 300~400ms. In case the time establishes shortly, it might be read as on-hook
instead of hook flash so that it is possible to close the call. Default is 500ms. Therefore, it provides
dialing of internal ports when connecting to other phones under internal line as following Routing
table so that additionally, it is possible to setup the number for easy pressing except service
provider’s registered number.
GW/CONFIG/ROUTE> show 0©
==========================================================================
1st Routing Table Show
==========================================================================
INTF PORT NUMBERS TRNC PREFIX POSTFIX DEST_ADDR LEVEL
==========================================================================
FXS 0 07077003240 11 0.0.0.0
FXS 0 200 3 0.0.0.0