Davolink DV-332 - Setting T.38 FAX

DV-332 Analog/Digital User Guide
77
Ö F711 starts FAX with PCM Codec of Passthrough Codec (passc) which is established without
Re-INVITE.
Ö M711 sends Re-INVITE with Codec which is established at passc.
/* Specific FAX sort is unable to GNG tone.*/
GW/CONFIG/FAX> change lv21 [f711 | m711] ©
Ö V.21 flag is detected at receiving party’s GW, execute pass-through FAX.
Ö F711 starts FAX with PCM Codec of Passthrough Codec (passc) which is established without
Re-INVITE.
Ö M711 sends Re-INVITE with Codec which is established at passc.
GW/CONFIG/FAX> change rfax [f711 | m711] ©
Ö When GW at sending party detects FAX tone (CED) which was sent from GW at receiving
party, execute pass-through FAX.
Ö F711 starts FAX with PCM Codec of Passthrough Codec (passc) which is established without
Re-INVITE.
Ö M711 sends Re-INVITE with Codec which is established Passthrough Codec (passc).
8.2.2 Setting T.38 FAX
According to established value, GW sends T.38 udptl message without Re-Invite or sends it after Re-
INVITE.
2) Configuration
FAX establishment acts through Telnet or Console
- Activating FAX mode
GW/CONFIG/FAX> change faxmode [all | specific port number] enable©
Ö Port or whole System is FAX activated/inactivated.
/* Input Command rightfully, print out “Apply Success…”, otherwise, print out command
guide.*/