Davolink DV-332 - Changing System Name

DV-332 Analog/Digital User Guide
97
8.8.3 Changing System name
When remoted connection, it shall be connected with IP address only so it’s hard to confirm the
exact connection where they want to connect. Accordingly, it is possible to confirm the connection
by using this function when changing system name for initial installation.
GW/SYSTEM> sysname DAVO©
New system name is DAVOLINK
DAVO:/SYSTEM>
DAVO:/SYSTEM> sysname Davolink©
New system name is Davolink
DAVOLINK:/SYSTEM>
DAVOLINK:/SYSTEM>
As above example, it is possible to setup both English & Korean. If the name is setup as like
installed place or client name, it shall be caused some confusion because prompt will be printed
with targeted sysname when remote connection. In case several GW is installed, it is possible to
change with figure or IP address as following.
DAVOLINK:/SYSTEM> sysname Davolink1©
New system name is Davolink1
DAVOLINK1:/SYSTEM> sysname Davolink2©
New system name is Davolink2
DAVOLINK2:/SYSTEM>