Davolink DV-332 - Page 96

DV-332 Analog/Digital User Guide
96
yes/no prompt mode (prompt) : YES
watchdog timer (wdt) : YES
*,# Processing Mode (dtp) : END_OF_DIGIT
web mode (web) : YES
telnet mode (telnet) : YES
telnet keepalive timer (keep) : 0 (sec)
local call feature mode (va) : YES(pickup number : *0)
ethernet wan speed type (wan) : AUTO
ethernet lan speed type (lan) : AUTO
telnet port (tport) : 6000
web port (wport) : 8000
digitmap mode (digitmode): NO
UPS mode (upsmode) : NO
CODEC filter value : KOREA
==========================================================================
GW/CONFIG/COMMON>
GW/CONFIG/COMMON> change tport 23©
Apply Success...
GW/CONFIG/COMMON> change wport 80©
Apply Success...
GW/CONFIG/COMMON> show©
==========================================================================
Common Configurations
==========================================================================
yes/no prompt mode (prompt) : YES
watchdog timer (wdt) : YES
*,# Processing Mode (dtp) : END_OF_DIGIT
web mode (web) : YES
telnet mode (telnet) : YES
telnet keepalive timer (keep) : 0 (sec)
local call feature mode (va) : YES(pickup number : *0)
ethernet wan speed type (wan) : AUTO
ethernet lan speed type (lan) : AUTO
telnet port (tport) : 23
web port (wport) : 80
digitmap mode (digitmode): NO
UPS mode (upsmode) : NO
CODEC filter value : KOREA
==========================================================================
GW/CONFIG/COMMON>
Above example explained that telnet port & web browser’s HTTP port is changed to general port
which we used normally. If forgetting the connection port after changing it because that port did
not often use, it’s impossible to connect by remote connection. In this case, there is no way but to
connect console & check & change it. So it required caution when changing.