DV-332 Analog/Digital User Guide
40
GW/CONFIG/VOIP>
By using above command “pfield”, it is possible to change, default value is “ADDR”, setting
/CONFIG/ADDRESS of each VIRTUAL_NUM number or each channel’s LOCAL-ADDR number shall use
as phone number field.
Addr : Virtual number which is setting in /CONFIG/ADDRESS table will use as phone number field’s
number
Voip : Refer [Phone Number Table] number of /CONFIG/VOIP
Voipd : Refer [Display Name Table] number of /CONFIG/VOIP
User : Use Phone number fileld’s number which detected CID number at FXO
Mynum : Use combination of setting number+transmitted sender’s number when digital port’s
competibility
Onlymy : Use setting No at random regardless of transmitted number when digital port’s
competibility
As same, it is possible to change Display name field & Contact field
GW/CONFIG/VOIP> dfield ©
usage : dfield addr|voip|user|mynum|onlymy|null
addr : /config/address table
voip : /config/voip display name table
user : user's calling number. ex)fxo's cid | trunk intf's calling number
mynum : operator add prefix calling number
onlymy: use only mynum without calling number
current dfield(display name) value is onlymy
current mynum is 0313873240
GW/CONFIG/VOIP>
Command “dfield” is using for changing chandisplay name. Default is “ADDR”
GW/CONFIG/VOIP> cfield ©
To Next Page
Loading...