Davolink DV-332 - Page 68

DV-332 Analog/Digital User Guide
68
GW/CONFIG/ADDRESS>
GW/CONFIG/ADDRESS> peer multi© /*this option delivers incoming PSTN calls to FXS ports*/
Intf : [FXS,FXO,EM]
=>fxo©
Nums : [peer number]
=>*99*©
IncNum : [the number of increment:default(1)]
=>0©
Count : [the count of increment:default(4)]
=>2©
Peer number 00 : *99*
Peer number 01 : *99*
GW/CONFIG/ADDRESS>
GW/CONFIG/ADDRESS> peer fxo 2 null© /*there are no peer addresses for FXO ports used in
headquarter-branch calls */
GW/CONFIG/ADDRESS> peer fxo 3 null©
GW/CONFIG/ADDRESS>
GW/CONFIG/ADDRESS> show
======================================================================
* ADDRESS TABLE SHOW *
======================================================================
INTF PORT VIRTUAL_NUM PEER-ADDR GROUP-PORT MODE L/RT
======================================================================
FXS 0 07077003241 NONE 200 Round_Robin C/1ST
FXS 1 07077003241 NONE 200 Round_Robin C/1ST
FXS 2 07077003241 NONE 200 Round_Robin C/1ST
FXS 3 07077003241 NONE 200 Round_Robin C/1ST
FXO 0 100 *99* 201 Round_Robin C/1ST
FXO 1 101 *99* 201 Round_Robin C/1ST
FXO 2 102 202 Round_Robin C/1ST
FXO 3 103 202 Round_Robin C/1ST
======================================================================
GW/CONFIG/ADDRESS>
Group port “201” consists of FXO port 0 and 1. And they receive PSTN calls and switch VoIP to PSTN
backup lines.
FXO 201 **11~ 4 0.0.0.0
You have to configure the route **11~ to FXO ports connected to PSTN lines. Group port “202”
consists of FXO port 2 and 3. And they are used to send and receive calls between headquarter and
branches.