Davolink DV-332 - Page 90

DV-332 Analog/Digital User Guide
90
Basically, if GW terminal establishes Type I, Type II also supported. In order to deliver caller ID
information to the phone shown caller ID & connected to GW, FXO/FXS port shall setup as following.
1) Setting FXO port
FXO port is for detecting caller ID information from PSTN line, establishment is as following.
GW/CONFIG/FXO> show©
===========================================================================
FXO Configurations Show
===========================================================================
[Voice Output Gain] (vgain)<-31 ~ 31> : dB
-2 -2 -2 -2
[PCM Input Gain] (igain)<-31 ~ 31> : dB
0 0 0 0
DTMF duration (dur) : 120 ms [FXO-->PSTN]
DTMF interval (intv) : 60 ms [FXO-->PSTN]
Inter digit timer(idt) : 5 sec [PSTN-->FXO]
Post digit timer(pdt) : 2 sec [PSTN-->FXO]
Wait mode (wm) : DIALTONE MODE [PSTN-->FXO]
Dialtone timer(dt) : 12 sec [Dialtone mode] [PSTN-->FXO]
Fxo dial connect mode(dcm) : disable [Dialtone mode] [PSTN-->FXO]
Passwd_mode (pm) : disable [PSTN-->FXO]
Password (ps) : 1002 [PSTN-->FXO]
Fxo password timer (pt) : 3 sec [PASSWORD MOD]
Wait dialtone time(wd) : 1500 ms [FXO-->PSTN]
Wait digit timer(wdt) : 7 sec [Announce mode] [PSTN-->FXO]
Wait connect from net (t2) : 60 sec [FXO-->IP]
Wait digit from net (t4) : 500 ms [IP-->FXO]
Release tone play (rtp) : 4 sec [FXO-->PSTN]
Silence Detection (sd) : Disabled [PSTN-->FXO]
Silence Period (sp) : 120 sec [PSTN-->FXO]
Silence Level (sl) : -50 dBm [PSTN-->FXO]
CallerID detection(caller) : [PSTN-->FXO]
DISABLE, DISABLE, DISABLE, DISABLE
CallerID_detect_timer(dct) : 4000 ms
Ring guard timer (rguard): 410 ms [PSTN-->FXO]
H/W ring det. (hwring) : 2 [PSTN-->FXO]
Connect mode (connect) : 0(wait the answer back) [PSTN-->FXO-->IP]
Flash hook time (fhtime) : 500 ms [FXO-->PSTN]
Force release time (frtime) : 0 minute [FXO<-->IP]
Fxs busy (sbusy) : NOANSWER [FXO-->FXS]