Davolink DV-332 - Page 92

DV-332 Analog/Digital User Guide
92
2) Setting FXS port
Differ from FXO ports which can detect caller ID from PSTN line, FXS port delivers information to
caller ID phone or keyphone system. Setting is as following.
GW/CONFIG/FXS> show©
===========================================================================
FXS Configurations Show
===========================================================================
Voice Output Gain (vgain) : dB
-2 -2 -2 -2
PCM Input Gain (igain) : dB
0 0 0 0
Caller id Generation mode (cid) :
DISABLE DISABLE DISABLE DISABLE
ring cadence on time (ron) : 1 sec
ring cadence off time (roff) : 2 sec
Polarity reversal (pola) : ENABLE
Dial Tone Type (dtype) : CONTINUOUS
Initial digit timeout(init) : 10 sec
Inter digit timeout(idt) : 5 sec
Post digit timeout(pdt) : 2 sec
hook flash guard time (guard) : 600 ms
Ring Vrms Value (vrms) :
60 60 60 60
CODEC filter value : KOREA
No answer timer(natimer) : 180
FXS/FXO|LBU One2One Mode(one2one) :
DISABLE DISABLE DISABLE DISABLE
FXO unblock time(ubtime) : 500 ms
DTMF duration (dur) : 120 ms
DTMF interval (intv) : 60 ms
Wait dialtone (wdt) : 2 sec
Ringing timer (ringing) : 200 sec
Early DTMF (edtmf) : DISABLE
Early DTMF Onhook guard (etime) : 1 sec
Force On-Hook (fon) : DISABLE
ForceOn-HookGuardTimer(ontimer) : 10 sec
Ring trip threshold (rtrip) : DOWN
FXS Codec Receive Gain (rg) : OFF
Private ring number(pri) : none
===========================================================================
GW/CONFIG/FXS>
GW/CONFIG/FXS> change cid all enable©