Days Strider MD 4 - Preparing the battery charger; Charging the batteries

45
Issued: 24.02.2005
STRIDER MD
It is imperative that you observe the
sequence for connecting and
disconnecting the battery charger.
(2.) Connect the battery charger mains
plug (5) to a mains socket and
switch on.
➨
The jack socket (3) for connecting the
battery charger is located on the left
of the tiller.
Switch the battery charger on at the toggle
switch (6).
➨
(1.) Connect the battery charger plug (4)
to the Strider charging socket.
➨
Connecting the battery
charger
Switching the battery
charger on
Charging the batteries
Switch the Strider off.➨
Switching off
Engaging
Engage the engaging lever for push
mode into the “drive“ position.
➨
12.2 Charging the batteries