60
Issued: 24.02.2005
STRIDER MD
Remove valve cap (1) - check air pressure.
Inflation pressure = 25 -28 PSI
18 - 20 hPa
1.8 - 2.0 bar
➨
Danger of injury due to overpressurised tyres!
The tyres will burst if inflated with too much air pressure
• Never inflate the tyres over the specified pressure.
Only use calibrated instruments to measure
the air pressure in the tyres (such as are
available at filling stations).
Screw the valve cap back on.➨
If you find any faults on your scooter during maintenance which are not
covered by the repair information, please contact your dealer.
Always remove faulty scooters from operation and secure them against
unauthorized use (remove key).
Maintenance and Inspection
Check the brakes by driving slowly and then braking.
Check that the lights and indicators are functioning correctly.
Make a visual check of wheels and tyres for damage and loss of
pressure.
➨
➨
➨
16.1 Daily maintenance before start of journey
16.2 Weekly inspections / tyre pressure
16.0Maintenance and Inspection
To Next Page
Loading...
