Decatur Electronics Genesis II Select - Configuring the VIP

Genesis II Select
™
User’s & Installation Manual
16/September/2015
22
t *GZPVSSBEBSEPFTOPUBVUPNBUJDBMMZTXJUDIUPTUBUJPOBSZ
mode when stopped, please check the menu feature
setup on the radar and make sure the VIP™ has been
activated.
The next step will walk you through setting up the VIP™ if it is not
being recognized by the radar. You can also refer to the menu feature
set up in the radar’s operator manual.
2.5.5 Conguring the VIP™
To get the Genesis II Select™ to recognize that the VIP™ has been
connected it may be necessary to go into the radar’s menu feature
and select the VIP™.
1. With the radar turned on and all power-up routines having been
ran, press and HOLD the Test button on the hand remote until
the word MENU is displayed on the radar. Then release the test
button.
2. Next, press the OPTN button several times until VIP™ is displayed.
3. Press the UP arrow (front antenna) button and make sure the
word AUTO is showing in the display.
4. Press the Test button again to exit the menu and save the setting.
The mode window will display “EXIT” and the radar will return to
normal operation. The VIP™ is now congured to the radar.