Decatur Electronics Genesis II Select - Range Setting; Stopwatch Mode

Genesis II Select
™
User’s & Installation Manual
16/September/2015
43
Clear a locked speed one of the following ways:
t 1SFTTUIF-0$,CVUUPOXIFOBOBOUFOOBJTUSBOTNJUUJOHBOEOP
target is present.
t $IBOHFUIFPQFSBUJOHNPEF
t 5VSOUIFBOUFOOBPòUIFOPOBHBJO
t 5IFMPDLFETQFFEXJMMSFNBJOXIFOZPVDIBOHFBEVBM
antenna transmission status from front to rear or rear to
front.
t :PVNBZVTFUIFMPDLGFBUVSFFWFOXIFOUIFSBEBSJTJO
Faster mode.
6.8 Range Setting
You can adjust the range (sensitivity) of the Genesis II Select™ in each
of the three operating modes independently:
t .PWJOH0QQPTJUF.PEF
t .PWJOH4BNF%JSFDUJPO.PEF[OPT]
t 4UBUJPOBSZ.PEF
The ve LED lights above the word RANGE indicate the target-
acquisition range.
Press the negative (–) or positive (+) side of the RANGE button to
decrease or increase the range setting. The range lights progressively
illuminate as you increase the distance. When all lights are on, the
unit is in maximum range. The range setting for each operating mode
will be remembered when the radar is powered o.
6.9 Stopwatch Operation Mode [OPT]
Calculate target speeds without transmitting a signal by using the
stopwatch mode. The stopwatch mode relies on the time/distance
formula to calculate target speeds by measuring the amount of time
a motor vehicle takes to travel a known distance.
SPEED = DISTANCE / TIME