page 33
05_Programmazione_en.fm
Machine programming
Bisky
Chapter 5 Machine programming
5.1 Tooling, adjustments and setting up of the machine
In order to manufacture certain type of biscuits it is necessary to change the nozzles or wire
cut moulds.
NOTE All the settings, adjustments and cleaning of the machine are to be carried
out only when the machine is switched off. The main door block switch must
be in "0" position and with the lock in place.
The main cut-out switch must be set to the 0 position and locked in this position with a padlock.
PERICOLO Serious injury can be caused to the personnel if the settings are carried out
with the machine under tension.
Dismantling phase of the fixed straight nozzles or straight nozzles with
rotation plate
1. Loosen the fastening knobs (1) and remove the front Plexiglas protective cover (2);
2. Loosen the knobs (3) that hold the wire cut plate or rotary nozzle plate in place;
3. Remove the plate by extracting through the space in the aluminium plate;
4. Fix the nozzles;
5. Insert the plate;
6. Fix the fastening knobs of the fixed straight nozzles or straight nozzles with rotation
plate (3);
7. Reposition the front Plexiglas protective cover (2) and fix the fastening knobs (1).
3
1
2
To Next Page
Loading...