page 86
07_Manutenzione_en.fm
Maintenance
Bisky
7.3 Cleaning method
ATTENTION Avoid the use of solvents that can damage synthetic materials. Do not use
petrol, naphtha, nitre-perchlorate diluent and trichloroethylene in particular..
Cleaning frequency
Parts that need to be
cleaned
Instruments & detergents and method
Stainless steel Use water and detergent, pass over with cloth and dry
immediately after
Control panel Clean with a dry and soft cloth
Electrical parts Use a vacuum-cleaner to remove dirt and dust
Frequency Parts to clean
Daily Extruding rollers
Daily Extruding mould, rotary nozzle plate or wire cut
mould ext
Weekly Control panel
Daily Conveyor belt assembly
To Next Page
Loading...