page 87
07_Manutenzione_en.fm
Maintenance
Bisky
7.4 Programmed maintenance
Standard maintenance, are all those operations that are carried out by specialised and
authorised personnel. Periodical inspections, foreseen interventions and maintenance that
are to be carried out under maximum safety conditions.
Operators qualification
The foreseen maintenance operations can be carried out only in maximum safety
conditions and by specialised and authorised personnel, trained, qualified the authorised
personnel that have read and fully understood this manual and this specific section.
Lubrication
The following lubricants are to be used on this machine :
• Grease type lubricants :
– Manual with grease pump
– Manual with brush
Periodical adjustments and check ups
Periodical adjustments and check ups
Parts and their names that
need periodical checking
Safety con-
trol fre-
quency
Procedure
Interlocking devices (micro-
switches)
Every 40
hours
Check the efficient functioning
Emergency stop button Every 40
hours
Check the efficient functioning
Frequency Parts to lubricate and
grease
Monthly Conveyor belt support-
ing rods
Monthly Motors
Monthly Electrical parts
Monthly Body and steel coverings
Monthly Air filter
To Next Page
Loading...