Delfin Bisky 600 - 6.7 Emergency Stop; 6.8 Re-starting After Emergency

page 63
06_Uso_en.fm
Use
Bisky
6.6 Starting of the machine
For the normal functioning of the machine you must proceed as follows:
1.Turn the main door block switch (IG) to position 1, this switch is found on the back bottom
guard;
2.Push the button RESET..
3.Push START.
6.7 Emergency stop
To stop the machine in case of an emergency you must push the button EMERGENCY (21)
positioned on the main control panel of the machine:
• The machine will stop.
• The emergency button will remain blocked.
NOTE The emergency's act exclusively on the frequency controller (inverter), and
not on the main electrical power supply of the machine. It is therefore not
possible to carry out maintenance on the machine unless the main power is
excluded from the machine by turning the main door block switch (IG)
placed on the back bottom guard.
6.8 The re-starting of the machine after an emergency has
been activated
1. Determine the cause for the emergency stop and eliminate the dangerous situation.
2. Extract the EMERGENCY button (21).
3. Push the RESET button.
4. Push the START button.