page 25
03_dati_tecnici_en.fm
Machine Characteristics
Bisky
• Adequate crane or lift, suitable for the machine weight.
• Steel cable Æ 20 type "RR" with textile threads.
• Safety hook type BK-10.
• Bell type 0-10000.
• Lifting arms.
Unpacking the machine
BEWARE
• Before unpacking the machine make sure that the box is free from damage or
obvious dents. In case of damage report it immediately to the truck driver.
• Respect the local laws and regulations for the removal of the box from your premises.
• The use of the lifting arms is to be used every time a machine is loaded or unloaded.
The following procedure is to be used when opening the box :
•Box:
a. Lift the box from the truck, make sure the steel cables/chain/belts are attached as
for in
Fig. 3.2 Lifting and moving of the packed machine
.
b. Place the machine on the ground.
c. Take out the nails and remove the cover.
d. Take out the nails on the side panels of the box.
e. Remove the machine accessories from the box.
• Fastening the machine onto the truck:
a. Extract the accessories .
BEWARE Any damage caused during the transport must be immediately
communicated to the Manufacturer also if there are parts not in conformity
with the packing list.
3.4 Preliminary operations
Check if the machine has been damaged during trasport
Verify by means of a visual inspection the state of the external and internal parts of the
machine. Make sure that there is no damage that can cause the malfunctioning of the
machine. Make sure the bolts, nuts and valves are properly fastened.
In case of damage
The damage caused by the transport company is to be attributed to them, and must be
communicated immediately to the manufacturer or local agent.
To Next Page
Loading...