page 40
05_Programmazione_en.fm
Machine programming
Bisky
FIXED STRAIGHT NOZZLES & VERTICAL TRAY MOVEMENT FOR
PYRAMID SHAPED BISCUIT
•N° OF ROWS
The value you digit must be equal to the number of rows of biscuits that can fit onto
one tray.
• TABLE DESCENDING TIME:
The value you digit will determine the speed of descend of the tray for the distance
between maximum table height and minimum table height.
• RETARD MOVEMENTS:
The value you digit will determine the quantity of dough that will be deposited
before the nozzle start to rotate.
•EXTRUSION TIME:
The value you digit will determine how much dough will be extruded (biscuit size).
• DEPOSITING SPEED:
The value you digit (from 1 to 100) will determine the speed at which the dough will
be extruded (speed of rollers).
• SUCTION TIME:
The value you digit will determine the suction time (quantity of dough) that will be
sucked back up the nozzle after each deposit.
• SUCTION ON/OFF:
IWhen the suction is OFF, the suction will start when the tray drops down after each
deposit (DOUGH DETACHMENT). If the suction is ON the tray conveyor table will drop
(DOUGH DETACHMENT) only after the suction has been completed.
• REPEAT CYCLE TIME:
The value you digit will determines the pause time of the belts after a tray has been
filled (automatic re-start of belts).
• NUMBER OF TRAYS:
The number you digit will determine how many trays of that recipe you will produce
in automatic mode.
•TRAY EDGE:
Il valore impostato in questo parametro determina lo spazio in mm tra il bordo della
teglia e il primo biscotto.
• ROW SPACE:
Il valore impostato in questo parametro determina lo spazio in mm tra un biscotto e
l’altro.
• HORIZONTAL DOUGH DETACHMENT:
ON/OFF enables, disables the horizontal dough detachment.
• PAUSE BEFORE SUCTION:
The machine pauses before the suction phase starts. This pause duration can be set.
To Next Page
Loading...