Figure 15. Two-post center-mount threaded round-hole installation
2 Slide the back bracket towards the post. Secure it to the post ange with two user-supplied screws. See item 2 and 3.
3 Repeat this procedure for the second rail.
Four-post threaded installation
NOTE
: For more installation instructions, see the installation labels attached to the rail assembly.
NOTE: For S5296F-ON installation instructions, see S5296F-ON four-post rack assembly.
1 Remove the tool-less latch castings from the front side of each ReadyRails assembly, as shown in the following illustration:
Use a torx screwdriver to remove the two screws from each front latch on the switch side of the rail. Remove the tool-less latch
casting. Retain the castings for future rack requirements.
28
S5200F-ON Series switch installation
To Next Page