Figure 23. S5296F-ON switch PSUs
1
PSU
NOTE: The S5200F-ON Series switch starts up when you connect the cables between the power supply and the power
source.
AC or DC power supply replacement
CAUTION
: Disconnect the power cable before removing the power supplies. Also, disconnect all power cables before servicing.
NOTE: The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S5200F-
ON Series switch.
NOTE: If a PSU fails, you must replace the entire unit. There are no eld serviceable components in the PSU. To request a
hardware replacement, see Dell EMC support.
NOTE: If you use a single PSU, install a blank plate in the other PSU slot. If you are only using one power supply, install the power
supply in the rst slot, PSU1. Install a blank plate in the second slot, PSU2.
1 Disconnect the power cable from the PSU.
2 Use the grab handle to slide the PSU out of the power supply bay.
3 Use the grab handle on the replacement PSU to slide it into the power supply bay.
4 Attach the power cables to the replacement PSU.
NOTE
: The switch powers up when the cables are connected between the power supply and the power source.
DC power supply to power source connection
Each DC powered switch comes with a set containing a prewired, 3-inch 8 AWG, power supply connector and a four-screw wiring block.
One set is provided for each DC PSU.
Power supplies
39
To Next Page
Loading...
