About this guide
This guide provides site preparation recommendations, step-by-step procedures for rack mounting and desk mounting your switch,
inserting modules, and connecting to a power source.
CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this equipment.
WARNING: Only trained and qualied personnel can install this equipment. Read this guide before you install and power up this
equipment. This equipment contains two power cords. Disconnect both power cords before servicing.
WARNING: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
Figure 1. Class 1 laser product tag
WARNING: When no cable is connected, visible and invisible laser radiation may emit from the aperture of the optical transceiver
ports. Avoid exposure to laser radiation. Do not stare into open apertures.
NOTE: Read this guide before unpacking the switch. For unpacking instructions, see Unpack.
Regulatory
• Marketing model S5232F-ON is represented by the regulatory model E21W and the regulatory type E21W005.
• Marketing model S5248F-ON is represented by the regulatory model E21W and the regulatory type E21W002.
• Marketing model S5296F-ON is represented by the regulatory model E26W and the regulatory type E26W001.
Topics:
• Related documents
• Information symbols
Related documents
For more information about the S5200F-ON Series (S5232F-ON, S5248F-ON, and S5296F-ON) see the following documents:
• OS10 Enterprise Edition User Guide
• OS10 Enterprise Edition Release Notes
• S5200F-ON Series Set-up Guide
• S5200F-ON Series Release Notes
• Open Networking Hardware Diagnostic Guide
NOTE
: For the most recent documentation, see Dell EMC support: www.dell.com/support.
1
About this guide 5
To Next Page
Loading...
Need help?
General