Dell 6100 - The SCSISelect Utility

System Overview 1-21
SCSI Backplane Board
Figure 1-17. SCSI Backplane Board
Table 1-3. Microprocessor Module Jumper Descriptions
Jumper Setting Description
J101 (default) Microprocessor is not installed in
adjacent slot. This jumper is useful
only when you are using in-target
probe (ITP).
Microprocessor is installed in
adjacent slot.
J105 (default) 200/66 MHz microprocessor
installed. Do not change.
J106 (default) Microprocessor is not installed in
adjacent slot. This jumper is useful
only when using ITP.
Microprocessor is installed in
adjacent slot.
jumpered
unjumpered
Ultra/Wide SCSI
cable connector (SCSI)
power input
connector (POWER)
server-management bus connector
(SERVER MANAGEMENT)
control (front) panel connector
(CONTROL PANEL)
6 SCA-2 compatible SCSI
connectors (SLOT
n
ID=
n
,
on other side)