Dell 6100 - System Error Messages; Table 3-2. System Messages

3-2 Dell PowerEdge 6100/200 System Service Manual
S
ystem Error Messages
Table 3-2 lists system error messages that can appear on the monitor screen.
These messages can help you find the source of a problem. Some of these error
messages indicate fatal errors. When a fatal error occurs, the system cannot usu-
ally be rebooted until an appropriate hardware change has been made.
10 Shutdown reg. read/write error
11 I2C error
Table 3-2. System Messages
Code Message
0002
Primary Boot Device Not Found
0010
Cache Memory Failure, Do Not Enable Cache
0015
Primary Output Device Not Found
0016
Primary Input Device Not Found
0041
EISA ID Mismatch for Slot
0043
EISA Invalid Configuration for Slot
0044
EISA config NOT ASSURED!
0045
EISA Expansion Board Not Ready in Slot
0047
EISA CMOS Configuration Not Set
0048
EISA CMOS Checksum Failure
0049
EISA NVRAM Invalid
0060
Keyboard Is Locked ... Please Unlock It
0070
CMOS Time & Date Not Set
0080
Option ROM has bad checksum
0083
Shadow of PCI ROM Failed
0084
Shadow of EISA ROM Failed
Table 3-1. Beep Codes
(continued)
Beep Code Error