Dell 6100 - Using the System Setup Program; When to Use the System Setup Program

Removing and Replacing Parts 4-1
Chapter 4
Removing and Replacing Parts
T
his chapter provides procedures for removing the components, assemblies,
and subassemblies in the system unit. Unless otherwise noted, each procedure
assumes the following:
•
You have performed the steps in “Precautionary Measures” found later in
this chapter.
•
You have removed the computer covers.
•
You can replace or reinstall a part by performing the removal procedure in
reverse order unless additional information is provided.
R
ecommended Tools
Most of the procedures in this chapter require the use of one or more of the fol-
lowing tools:
•
Small flat-blade screwdriver
•
Wide flat-blade screwdriver
•
Number 1 and number 2 Phillips-head screwdrivers
•
Chip-removal tool
•
1/4
-inch nutdriver
•
Tweezers or long-nose pliers
•
Small plastic scribe
•
Integrated circuit (IC) removal tool
Also, use a wrist grounding strap as explained in the next section, “Precaution-
ary Measures.”