4-10 Dell PowerEdge 6100/200 System Service Manual
Figure 4-9. Hard-Disk Drive Removal
5. Remove the four mounting screws that attach the hard-disk drive to the
carrier.
6. Disconnect the hard-disk drive from the connector on the back of the
carrier, and lift the drive from the carrier.
NOTE: Dell recommends that you use only drives that Dell has tested and
approved for use with the SCSI backplane board.
After you replace the drive and reinstall the carrier in the bay, turn on the
system, if applicable. The online indicator lights, indicating power is being sup-
plied to the hard-disk drive. With the controller connected, the activity indicator
lights when the controller spins up the drive.
CAUTION: When disconnecting the hard-disk drive from the con-
nector, grasp the connector, not the cable, to avoid damaging the
connector.
screw (4)
connector
carrier
hard-disk drive
To Next Page
Loading...
