Dell 6100 - Drives; Figure 4-4. Drive Hardware

Removing and Replacing Parts 4-5
D
rives
Figure 4-4 shows an example of drive hardware that can be installed in the com-
puter. Refer to this figure when you perform any of the procedures in the
following subsections.
Figure 4-4. Drive Hardware
There is a plastic air damper over the slots in the chassis where the interface
connectors pass between the power supply bay area and the system board area.
The damper assists with the proper air flow from the power supply fan(s)
through the internal and external drive bays to lower the drives’ temperature.
SCSI hard-disk
drive bay (6)
SCSI CD-ROM
drive
3.5-inch diskette drive
DC power cable
diskette drive
interface cable
diskette drive
interface connector
(FLOPPY)
system board
Ultra/Wide SCSI
interface cable
Ultra/Wide SCSI host
adapter connector (SCSI B)
Ultra/Wide SCSI host
adapter connector (SCSI A)
Ultra/Wide
SCSI interface
cable