System Setup Program A-11
Plug and Play Configuration Submenu
Figure A-6. Plug and Play Configuration Submenu
82450GX C0 Host
Retry Timer
Increases system performance (in some cir-
cumstances) if set to Enable, but is not
compatible with 2.1 specification PCI-to-
PCI bridge devices. Default is Auto
Configure. This option is used with
82450GX C0 stepping only.
82450GX C0 P2P
Mode
Increases system performance (in some cir-
cumstances) if set to Disable, but is not
compatible with PCI-to-PCI bridge
devices. Default is Enable. This option is
used with 82450GX C0 stepping only.
AERR Mode Enables (default) or disables address parity
error detection on the microprocessor bus.
PERR Mode Enables or disables (default) detection of
PCI bus protocol violations.
Table A-6. Advanced Chipset Configuration
Submenu Categories
(continued)
Category Function
Latency Timer (PCI Clocks) 96
Boot With PnP OS None
F1 Help
ESC Back
Enter Select
Previous Item
Next Item
Select Menu
F5 Setup Defaults
F6 Previous Value
F10 Save & Exit
Plug and Play Configuration
To Next Page
Loading...
