Removing and Replacing Parts 4-7
Externally Accessible Drives
Figure 4-6. Externally Accessible Drives Removal
All of the externally accessible drives have drive-mounting rails. To remove a
drive assembly from one of the externally accessible drive bays, follow these
steps:
1. Remove the front bezel.
2. Disconnect the DC power cable and the interface cable from the back of
the drive.
Be sure to record the power connector number and interface cable connector
identification.
3. Press inward (toward center of drive) on the two drive-release tabs, and
slide the drive out of the bay.
drive-release
tab (2)
3.5-inch diskette
drive
CD-ROM drive
To Next Page
Loading...
