Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in
Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the
solid-state drive from M.2 slot one.
5. Remove the solid-state drive from M.2 slot two.
6. Follow the procedure from step 1 to step 4 in Removing the hard drive, if applicable.
7. Remove the
solid-state drive from M.2 slot three, if applicable.
8. Remove the solid-state drive from M.2 slot four, if applicable.
9. Remove the solid-state drive interposer board, if applicable.
10.Remove the rear-I/O cover.
11. Remove the speakers.
12. Remove the
computer base.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the removal procedure.
50
To Next Page
Loading...
