Connect the right power-adapter port cable to the connector at the bottom of the system board.
Next steps
1. Install the system board.
2. Install the left power-adapter port.
3. Install the heat-sink assembly.
4. Install the
computer base.
5. Install the rear-I/O cover.
6. Install the solid-state drive interposer board, if applicable.
7. Install the solid-state drive in M.2 slot four, if applicable.
8. Install the solid-state drive in M.2 slot three, if applicable.
9. Follow the procedure from step 5 to step 8 in
Installing the hard drive, if applicable.
10.Install the solid-state drive in M.2 slot two.
11. Install the solid-state drive in M.2 slot one.
12. Install the wireless card.
13. Install the
memory modules.
14. Install the battery.
15.Install the base cover.
16.Follow the procedure in After working inside your computer.
Keyboard
Removing the keyboard
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the memory modules.
5. Remove the wireless card.
6. Remove the
solid-state drive from M.2 slot one.
7. Remove the solid-state drive from M.2 slot two.
73
To Next Page
Loading...
