About this task
The following image indicates the location of the graphics card and provides a visual representation of the installation procedure.
Steps
1. Place the graphics card on the system board and align the screw holes on the graphics card with the screw holes on the system
board.
2. Replace the three screws (M2x3) that secure the graphics card to the system board.
3. Replace the two screws (M2x3) that secure the two graphics-card cables to the graphics card.
4. Connect the graphics-card power cable to the graphics card.
Next steps
1. Install the
heat-sink assembly.
2. Install the computer base.
3. Install the rear-I/O cover.
4. Install the solid-state drive from M.2 slot four, if applicable.
5. Install the
solid-state drive from M.2 slot three, if applicable.
6. Follow the procedure from step 5 to step 8 in Installing the hard drive, if applicable.
7. Install the solid-state drive in M.2 slot one.
8. Install the wireless card.
9. Install the memory modules.
10.Install the
battery.
11. Install the base cover.
12. Follow the procedure in After working inside your computer.
Left power-adapter port
Removing the left power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
63
To Next Page
Loading...
