2. Install the right power-adapter port.
3. Install the system board.
4. Install the left power-adapter port.
5. Install the heat-sink assembly.
6. Install the
computer base.
7. Install the display assembly.
8. Install the rear-I/O cover.
9. Install the
touchpad.
10.Install the coin-cell battery.
11. Install the speakers.
12. Install the audio daughter-board.
13. Install the card-reader board.
14. Install the solid-state drive interposer board, if applicable.
15.Install the solid-state drive in M.2 slot four, if applicable.
16.Install the solid-state drive in M.2 slot three, if applicable.
17. Follow the procedure from step 5 to step 8 in
Installing the hard drive, if applicable.
18.Install the solid-state drive in M.2 slot two.
19.Install the solid-state drive in M.2 slot one.
20.Install the wireless card.
21. Install the
memory modules.
22.Install the battery.
23.Install the base cover.
24.Follow the procedure in After working inside your computer.
78
To Next Page
