Next steps
1. Install the camera.
2. Install the display panel.
3. Install the display assembly.
4. Install the battery.
5. Install the base cover.
6. Install the microSD card.
7. Follow the procedure in after working inside your computer.
Display hinges
Removing display hinge
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the display assembly.
6. Remove the display panel.
Steps
1. Rotate the left hinge and hinge cap upwards to the display cover as shown in the image below.
NOTE:
Make sure you rotate only the hinges to the unlock the position, the hinge caps will not rotate until the hinges
are in the unlock position.
2. Pull the display cable and the rubber stopper out of the left hinge.
66
Removing and Installing
To Next Page
Loading...
