System Overview 1-13
0DLQ0HPRU\
Memory can be increased to a maximum of 384 megabytes (MB) by installing
combinations of 3.3-volt (V) 32-, 64-, and 128-MB dual in-line memory modules
(DIMMs) in the three DIMM sockets on the system board. Only 100-megahertz
(MHz) DIMMs are supported.
NOTE: The system is designed for peak performance with specific DIMMs that
are validated through rigorous testing. The system may not recognize other
synchronous dynamic random-access memory (SDRAM) DIMMs and may fail
power-on self-test (POST).
The computer supports ECC or non-ECC memory. The computer’s ECC sup-
port, which is built into the system board, corrects single-bit errors and detects
all multiple-bit errors. To use the ECC support, all installed DIMMs must be
ECC DIMMs.
For more information about the memory configurations, see “Adding Mem-
ory” in Chapter 2 of the
Reference and Troubleshooting Guide
.
To Next Page
Loading...
Need help?
General