Removing and Replacing Parts 4-11
3ULPDU\+DUG'LVN'ULYH
)LJXUH 3ULPDU\ +DUG'LVN 'ULYH 5HPRYDO
5HPRYH WKH EH]HO
5HPRYH WKH WZR GULYHDVVHPEO\ PRXQWLQJ VFUHZV
VHH
)LJXUH
/LIW WKH SULPDU\ KDUGGLVN GULYH RXW RI WKH FDUG JXLGH DVVHPEO\
'LVFRQQHFW WKH '& SRZHU DQG LQWHUIDFH FDEOHV IURP WKH EDFN RI
WKH SULPDU\ KDUGGLVN GULYH
To reinstall the primary hard-disk drive, be sure that the drive’s circuit board is
positioned toward the front of the chassis.
When you replace a hard-disk drive, be sure to set the jumpers on the replace-
ment drive the same as the jumpers on the drive you removed. For additional
information about jumper settings on EIDE drives, see “EIDE Subsystem” in
Chapter 1.
primary hard-disk drive
card guide assembly
drive-assembly
mounting screws (2)
To Next Page
Loading...
Need help?
General