Attaching the cable control bars to the standard-mount bracket
1. Mount the Edge Gateway on the wall using the standard-mount bracket or quick-mount bracket.
2. Place the cable control bar on the mounting bracket and secure it to the notch.
CAUTION: Use the top cable control bar only with coaxial cable connections. Do not use with antennas.
3. Align the screw holes on the cable control bar with the screw holes on the mounting bracket.
4. Tighten the six M3x3.5 mm screws that secure the cable control bar to the mounting bracket.
NOTE: Torque the screws at 5±0.5 kilograms-centimeter (11.02±1.1 pounds-inch).
36 Installing your Edge Gateway
To Next Page
Loading...
Need help?
General
