Dell Edge Gateway 3003 User Manual

● Subnet mask: 255.255.255.0
● DHCP server: Not applicable
1. On the host computer, configure the Ethernet adaptor that is connected to the Edge Gateway with a static IPv4 address
under the same subnet. Set the IPv4 address to 192.168.2.x (where x represents the last digit of the IP address, for
example, 192.168.2.2).
NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between
192.168.2.2 to 192.168.2.254.
2.
Set the subnet mask to 255.255.255.0.
Appendix 93

Dell Edge Gateway 3003 Specifications

General

Brand	Dell
Model	Edge Gateway 3003
Category	Gateway
Language	English